If this feature is enabled, the command station will keep in its reminiscence separate controls and registers for Button 0 when traveling in the forward direction and the reverse direction. Which means that if you are traveling within the ahead route and press button 0, the ahead headlight will come on. Your throttle will mirror this as properly, by toggling the operate standing on-display when you change path. A brand new window will seem which shows all of the "nodes" in your LCC network, which is able to embody trains and consists within the operational memory of the system, in addition to any linked LCC throttles, boosters, and different LCC equipment. The CS-105 shops consists in persistent storage. This setting might be saved in persistent storage and the CS-105 will remember it after a energy cycle. When you modify directions to reverse, the reverse headlight shall be off till you press Button 0 once more. Set IP handle. Enter the IP address (often the primary three numbers are pre-filled for you and you solely must enter the final number) and press Save.

That is convenient, because operators do not should memorize which button quantity performs what function. Use this IP deal with and port quantity 12021 for the JMRI Connection Profile. After getting arrange a JMRI connection to your CS-105, you may view and modify the internal roster knowledge through a DecoderPro or PanelPro interface for any locomotive at any time. The CS-105 options a bootloader which can be utilized to perform software updates on the system in the field at any time, assuming you could have entry to a firmware file. To modify the roster information for any of the locos in the system, choose it from inside the window, and then press "Open Configuration dialog." The program could take a number of moments to obtain the contents of the roster file from the command station. Once within the Roster Settings menu, you'll be offered with the entire options for the loco.

This entry will exist solely till the system powers down, whether or not it's ever given any commands. This record in reminiscence is typically referred to because the "stack." This memory allows the CS-105 to generate periodic messages to DCC and M/M decoders as required by the protocol commonplace, in addition to present info for a throttle or pc software program about the current velocity and capabilities for a given practice upon request (typically when a practice is acquired by a throttle). The default choice is 128 velocity steps for DCC decoders, and protocol version II for M/M decoders. The CS-105 supports F0 to F68 for DCC decoders, and F0 to F4 for Märklin-Motorola decoders. The TCS Command System supports more than one throttle driving the identical locomotive. Note: This characteristic assumes that your decoder is in a "default" state where F0F and F0R outputs out of your decoder are tied to the same button (F0), and are configured for directional lighting.

The command station will help DCC Long addresses from 0000 to 10239. Your decoder may or may not assist addresses above 9999. Check along with your producer if you're unsure. If the facility provide is unplugged, plug it in and verify the power LED. The Track LED and the WiFi Full/Error LED are quickly blinking in an alternating fashion. By default F2 is momentary and all different functions are latching. Saved Networks. Pick the network identify that the CS-105 broadcasts (default LAYOUTWIFI). Solo Unit is the default configuration, and makes no adjustments to the behavior and operation of the loco. This modifications the relative show of forward/backward on the throttle show, and in addition adjustments which locomotive will sound the horn, if the given function’s consist behavior is configured to "Current Cab Only". When selecting any of the consisted locomotives on a throttle, your complete consist can be operated: speed control and operate management commands will robotically act on the consist, even when the given LCC throttle doesn't support the consisting protocol. To pick the displayed title of a given function quantity, go into Functions, select the quantity, then Display.